Форум поддержи и обмена опытом пользователей оборудования RouterBOARD и операционной системы RouterOS Латвийского производителя MikroTik
https://forummikrotik.ru/
Знаете это?
Код: Выделить всё
[admin@MikroTik] > interface print
Flags: X - disabled, D - dynamic, R - runningСпециально же для сомневающихся написано! Ну читайте же уже!What TX-power values can I use?
... In general, tx-power controlling properties should be left at the default settings.
What TX-power-mode is the best?
TX-power-mode tells the wireless card which tx-power values should be used. By default, this setting is set to default.
default means that the card will use the tx-power values from the cards eeprom and will ignore the setting what is specified by the user in the tx-power field.
card-rates means that for different data rates the tx-power is calculated according to the cards transmit power algorithm from the cards eeprom and as an argument it takes tx-power value specified by the user.
all-rates-fixed means that that the card will use one tx-power value for all data rates which is specified by the user in tx-power field.
Note that it is not recommended to use 'all-rates-fixed' mode as the wireless card tx-power for the higher data rates is lower and by forcing to use the fixed tx-power rates also for the higher data rates might result in the same problems like in the previous question about tx-power setting. In the case of MikroTik Radio devices, the power will not be higher than the power written in the EEPROM. For most of the cases if you want to change the tx-power settings it is recommended to use the tx-power-mode=card-rates and it is recommended to lower and not to raise tx-power. In case of AR9300 and newer Atheros wireless chipsets "tx-power-mode=all-rate-fixed" is the only option as "card-rates" option isn't working on those chipsets.
What is adaptive-noise-immunity setting?
Adaptive Noise Immunity (ANI) adjusts various receiver parameters dynamically to minimize interference and noise effect on the signal quality [1] This setting is added in the wireless driver for Atheros AR5212 and newer chipset cards
Да? Но как только поменяю `Тх Power` в CAPsMan контролёре, тaк сразу меняется `Current TX power` на точке.Erik_U писал(а): ↑08 май 2019, 20:14
Знаете это?А с вашими интерфейсами на картинке что?Код: Выделить всё
[admin@MikroTik] > interface print Flags: X - disabled, D - dynamic, R - running
